460Z5 Electric Paper Guillotine

User Guide

Below you will find a useful guide to programming a cut and adjusting the cutting depth and paper squareness…

460 Z5 Electric Paper Cutter / Guillotine

SRA2 Cutting with digital display

460 Z5 Electric Paper Guillotine
Programming a cut and adjusting the cutting depth and paper squareness…

Programming a single cut value
With the display in the ready to use state Enter the length value + decimal and press enter The backguage will move to the position selected.

Programming multiple cuts (max 80 values, min step 0.1 mm, last cut 45 mm)
With the display in the ready state Enter the first ( longest ) value + enter The cursor will move to the next step( backlit = active )
Repeat the process and many times as needed Press enter twice to end the programming sequence and return to 1st value

To access any step use the UP AND DOWN arrows ( backlit = active ), then press ENTER and clear overwrite the value as needed
Press ENTER twice to exit.

Selection of a program memory (80 available)
Press the ENTER button and scroll to the program nr is flashing/ backlit, press ENTER, use the UP / DOWN button to scroll to the program required, press ENTER to access. – The programs are not nameable

Pressing only/ gauging the cut position
Set the cut length.
Put the paper into position and knock it up square.
Press the PRESS button and right side cut button simultaneously.
The light bars are now live and the front table guarded.
The press clamp will descend and clamp the paper according to the press force that is pre-set.
If the position is correct the 2 cut buttons can be pressed to make a cut.
Or if the position is not correct press reset to raise the press clamp to home position.

Pressing and cutting in 1 step
Set the cut length.
Put the paper into position and knock it up square.
Press the 2 CUT buttons simultaneously.
The lightbars are now live and the front table guarded.
The press will descend and clamp the paper.
Then the blade will descend and cut the paper.
You need to press both buttons for the full cut cycle or the cycle will be interrupted part way through and cannot be re-commenced part way through.

What if i interrupted the cut cycle?
You need to press RESET and the blade will raise to home position and then the press will raise to home position.
Then you can start again a cut cycle

Adjustment of blade end of stroke
This can be adjusted by using the long allen key in the hole in the top cover.
It is only to be used after the blade is re- ground (lowered), or replaced (raised), it is not to be used to compensate for a dull blade not cutting the paper !!!
A fraction of a turn is all that is needed.
If you lower the blade too much you may jam the machine and break it !!!

Leveling the blade
If the of the 460Z5 Electric Paper Cutter Guillotine blade is cutting on one end and not the other the blade needs to be re- leveled by loosening the blade screws, then using the small allen key, either turn clockwise to lower that section of the blade or ant-clockwise to raise that section of the blade. Tighten the blade screws once adjustments have been made.

 

Contact Us

10 + 2 =